Polymaker LW-PLA 3D Printing Filament 1.75mm, 0.8kg, Wood | Pre-foamed lightweight PLA with 0.9 g/cm3 density and matte finish for RC aircraft parts and weight-sensitive prints
Compare all 6 Polymaker PLA Matte 800g listings →
Is this a good price? Every Thursday we email the cheapest price per kg for each major material, plus our best buy of the week.
Product Details
- PRE-FOAMED PLA FILAMENT: Typical density is 0.9 g/cm3. Its lightweight structure forms before printing, so it does not rely on in-nozzle expansion like active-foaming filaments
- RC AIRCRAFT APPLICATIONS: Print wings, airframes and other parts where weight matters. The matte surface softens layer lines; final part weight also depends on walls, infill and geometry
- TDS STARTING SETTINGS: With a 0.4mm nozzle, use 190-210°C nozzle, 25-60°C bed and 50-100mm/s speed. Turn the part-cooling fan on; an enclosed chamber is not required
- TUNE FOR YOUR PRINTER: Test a small part first. If you see stringing or poor first-layer adhesion, adjust temperature, retraction and bed setup. TDS retraction guidance: 3-6mm at 40-60mm/s.
- POLYMAKER LW-PLA 0.8KG SPOOL: Net filament weight is 0.8kg. Store dry; if moisture affects printing, the TDS recommends drying at 55°C for 6 hours. Check spool clearance in multi-material feeders
From the listing on Amazon.
View our other Polymaker listings here.
View our other PLA listings here.
Keep your filament dry, view our gear here.
Printing Polymaker PLA
Polymaker PLA in Matte Wood runs on the PLA profile below, and this listing is a 0.8kg spool. PLA is best suited to light parts such as RC aircraft, cosplay props and large display pieces. Brands and even individual spools vary, so treat these as starting points and run a quick temperature tower to lock in the sweet spot for your printer.
Ranges checked against colorFabb, Polymaker and Bambu Lab data. Heat resistance is the heat deflection temperature (HDT). Read our LW-PLA filament guide for bed adhesion, drying, troubleshooting, and material-specific tips.
Nozzle Compatibility
This is an unfilled plastic, so it is not abrasive: a brass nozzle works and lasts, and so does hardened steel. With hardened steel, print about 5 to 10°C hotter.
Based on Bambu Lab and Prusa guidance. More in our nozzle types guide.